FIBERTHREE
F3 TPU HSE filament spool (orange), side view
01 / 02Side view
TPU Shore 92–95A Safety colours

F3 TPU HSE

TPU in the signal colours orange and blue with Shore 92–95A, extremely impact-resistant and elastic, resistant to oils and solvents, with a glossy surface.

COLOUR · Orange
  • 01Thermoplastic polyurethane (TPU), Shore 92–95A
  • 02Safety colours orange and blue
  • 03Extreme impact strength and elasticity
  • 04High resistance to oil and solvents
  • 05Temperature-stable up to 100 °C
  • 06Excellent adhesion to the print bed, glossy surface
01Properties

Measured on the printed part

Values according to the technical data sheet, measured on printed test specimens, just as you will use the material. “–” means: not stated in the data sheet.
PropertyTest directionUnitValue
MECHANICAL
Density–g/cm³1.16
Yield stress (ISO 527)–MPa41
Tensile modulusx-y 0°MPa85
Elongation at breakx-y 0°%< 350
Hardness (ISO 868)–Shore92–95 A
THERMAL
Heat resistance–°C100
ELECTRICAL & OTHER
Water absorption (24 h)–%> 0.2
Volume resistivity–Ω·m> 10¹²
Comparing the TPU filaments PER DATA SHEET
TENSILE MODULUS X-Y 0° · MPA
TPU 80A
28 MPa
TPU HSE
85 MPa
TPU 98A
39 MPa
HEAT RESISTANCE · °C
TPU 80A
100 °C
TPU HSE
100 °C
TPU 98A
120 °C
F3 TPU HSE is the stiffest of the three TPU filaments. In signal colours for highly visible protective and impact parts.
02Material & processing

Impact-resistant and highly visible

Material properties

Thermoplastic polyurethane with a Shore hardness of 92 to 95A in the safety colours orange and blue. The material is extremely impact-resistant and elastic, absorbs moderate amounts of water and is highly resistant to oils and solvents.

Temperature-stable up to 100 °C. Recommended for elastic parts with high impact strength, such as sealing, pressure and impact surfaces. Glossy surface.

Processing notes
  1. 01Leave the print bed cold.
  2. 02Print slowly: 30 mm/s.
  3. 03Printable with any nozzle. No abrasion-resistant nozzle is needed.
Print parameters
NOZZLE240 °C
PRINT BEDcold
MINIMUM NOZZLE DIAMETER0.4 mm
SPEED30 mm/s
03Printers & downloads

Tested and documented

Tested on
  • 01Prusa MK4 (test specimens according to data sheet)
  • 02Prusa MK3S+ / MK4S / Core One / Core One L / XL / HT90
  • 03Bambu Lab A1 / P1S / X1C / H2D
Downloads
DocumentVersionLanguage
Technical data sheetDE v11/2025 · EN v12/2025DE · EN
Safety data sheetv02DE · EN
Slicer profilesOn requestENQUIRE
04More

Similar materials

Further materials from our range that suit similar applications.