FIBERTHREE
F3 TPU 98A filament spool (black), side view
01 / 03Side view
TPU Shore 98A flexible

F3 TPU 98A

Firm TPU with Shore hardness 98A, impact-resistant even under dynamic loads, temperature-stable up to 120 °C and with a glossy surface.

COLOUR · Black
  • 01Thermoplastic polyurethane (TPU), Shore 98A
  • 02Extreme impact strength under dynamic load
  • 03Extreme elasticity, moderate water absorption
  • 04High resistance to oil and solvents
  • 05Temperature-stable up to 120 °C
  • 06Excellent adhesion to the print bed, glossy surface
01Properties

Measured on the printed part

Values according to the technical data sheet, measured on printed test specimens, just as you will use the material. “–” means: not stated in the data sheet.
PropertyTest directionUnitValue
MECHANICAL
Density–g/cm³1.23
Yield stress (ISO 527)–MPa37.23
Tensile modulusx-y 0°MPa39
Tensile strengthx-y 0°MPa11
Elongation at breakx-y 0°%< 250
Hardness (ISO 868)–Shore98 A
Compression set (24 h, 70 °C)–%50
THERMAL
Heat resistance–°C120
ELECTRICAL & OTHER
Water absorption (24 h)–%> 0.2
Volume resistivity–Ω·m> 10¹²
Comparing the TPU filaments PER DATA SHEET
TENSILE MODULUS X-Y 0° · MPA
TPU 80A
28 MPa
TPU HSE
85 MPa
TPU 98A
39 MPa
HEAT RESISTANCE · °C
TPU 80A
100 °C
TPU HSE
100 °C
TPU 98A
120 °C
At 120 °C, F3 TPU 98A is the most heat-resistant of the three TPU filaments.
02Material & processing

Resilient and elastic

Material properties

Thermoplastic polyurethane with a Shore hardness of 98A. The material is extremely impact-resistant even under dynamic load, elastic, absorbs moderate amounts of water and is highly resistant to oils and solvents.

Temperature-stable up to 120 °C. Recommended for elastic parts with high impact strength, such as sealing, pressure and impact surfaces. Glossy surface.

Processing notes
  1. 01Leave the print bed cold.
  2. 02Print slowly: 30 mm/s.
  3. 03Keep retraction small: direct drive below 1 mm.
Print parameters
NOZZLE220–240 °C
PRINT BEDcold
MINIMUM NOZZLE DIAMETER0.4 mm
SPEED30 mm/s
03Printers & downloads

Tested and documented

Tested on
  • 01Prusa MK4 (test specimens according to data sheet)
  • 02Prusa MK3S+ / MK4S / Core One / Core One L / XL / HT90
  • 03Bambu Lab A1 / P1S / X1C / H2D
Downloads
DocumentVersionLanguage
Technical data sheetDE v10/2024 · EN v12/2024DE · EN
Safety data sheetv01DE · EN
Slicer profilesOn requestENQUIRE
04More

Similar materials

Further materials from our range that suit similar applications.